TexasCHLforum.com

Looking for the “correct” wall anchor size. Tried a search and found a recommendation for 4-6-8.

They don’t work. . But I have 100! Tne lip at the end is too small it goes into the chamber.

Anyone using these can you please give me the correct size?

Thnx

Not sure why you are having an issue. I use these 4-6-8 x 7/8" and they work fine for me.

https://www.amazon.com/Hillman-370326-R ... 246&sr=8-5

I don’t think these will protect the firing pin.

Having issues posting pic

Attached

Interesting. Below is a wall anchor from the link above compared to a "real" 22 snapcap.

That link is exactly what and where I ordered. Numbers on my box match.

Both an actual round and my aluminum snap caps measure .272. These anchors measure .234.

I don't get it. Why not just order some snap caps and be done with it? Surely your time running all over the place trying to find one that works is worth something.

call me unlearned.
i had no idea and had not heard of using plastic anchors for practice snap caps
i bet i have a hundred of these in all sizes taking up space in a drawer


sorry you were having hard time finding right ones, BUT THANKS a million for educating me on a simple device

I just measured a few of mine at the rim and they varied between .270" and .272". I purchased mine box over a year ago.

kg5ie wrote: ↑Tue May 25, 2021 8:53 pm I don’t think these will protect the firing pin.

Even though the center is hollow the firing pin should strike the outer edges; at least I assume that's the theory behind using them