TexasCHLforum.com

This is a ruger new model single six with both 22lr and 22 wmr cylinders.
Can anybody Identify the small pin and what part of the gun it may go to.
Thank you.

I don’t know if this will help my friend. Good luck. I hate it when I have parts left over.

https://www.gunpartscorp.com/gun-manufa ... e-6?page=4

8 or 31
Cylinder latch spring plunger
Pawl spring plunger

BHill wrote: ↑Thu Sep 12, 2019 10:08 pm https://www.gunpartscorp.com/gun-manufa ... e-6?page=4

8 or 31
Cylinder latch spring plunger
Pawl spring plunger

31 should be stepped to hold the spring. Don't know 8 could be possible.

carlson1 wrote: ↑Thu Sep 12, 2019 10:04 pm I don’t know if this will help my friend. Good luck. I hate it when I have parts left over.

3E9CB682-5A46-4B30-A30D-E09537A27285.jpeg

Trust me, I've no doubt taken enugh stuff apart in my life to be able to put it back together.
My issue is I wasn't the one to take it apart. But it's now mine once I go pick it up from the ffl next week
And thank you as always.

It looks like part number 24 to me.

03Lightningrocks wrote: ↑Thu Sep 12, 2019 10:22 pm It looks like part number 24 to me. It holds the grip from slipping away from each other after they are tightened onto frame.

This is my thought as well.

cheezit wrote: ↑Thu Sep 12, 2019 10:24 pm

03Lightningrocks wrote: ↑Thu Sep 12, 2019 10:22 pm It looks like part number 24 to me. It holds the grip from slipping away from each other after they are tightened onto frame.

This is my thought as well.

I am not positive as to it's purpose but that is it for sure.

03Lightningrocks wrote: ↑Thu Sep 12, 2019 10:25 pm

cheezit wrote: ↑Thu Sep 12, 2019 10:24 pm

03Lightningrocks wrote: ↑Thu Sep 12, 2019 10:22 pm It looks like part number 24 to me. It holds the grip from slipping away from each other after they are tightened onto frame.

This is my thought as well.

I am not positive as to it's purpose but that is it for sure.

A grip pin stops them from rotating and maintains the correct location.
I only hope it's that simple

BHill wrote: ↑Thu Sep 12, 2019 10:08 pm https://www.gunpartscorp.com/gun-manufa ... e-6?page=4

8 or 31
Cylinder latch spring plunger
Pawl spring plunger

On gunparts site , page 3 , part 24 hammer plunger pin is looking like the part. It gives a good picture.