TexasCHLforum.com

so i got out of the class a few hours ago
i have an EAA WHITNESS-P and i had 3 fail to feed on the range and as far as im conserned thats unacceptable
if anyone here happens to know some things about that type of gun i would like to hear from you

First things I ask are was it clean & properly oiled?
Is it brand new & needs 400 rds through it to break it in?

EAAs are nice peices. Make sure you cleaned all the grease they put on them at the factory and oil it very lightly. Lunchbox is right about the break in. Also, I like to take a Dremmel wheel to the ramp and polish it. Sometimes there are a few rough parts on the surface and with a little polish, they will smooth right out. Check your magazine and make sure it is clean and very lightly oiled as well as the spring. If the spring is weak, try stretching it out a little before you put the magazine back together. Hope that helps. Welcome to the room.

ok it was clean and oiled but i used rem. oil and it seems to dry fast. i will try to polish out the ramp some the mag seems ok i used 2 mags it failed with both
does anyone know where i can get good holsters for it im thinking in the waist band pattle type any thoughts

Put it in the Market section here. Someone may have on for sale.

wheres a good place to shoot in friendswood

http://psc-range.com or http://www.texas-city-tx.org/ShootingRange.htm

- Jim

+1 for the Texas City range. It is a long drive from our area but worth it. Very well run. Very friendly too.

Ditto Texas City