TexasCHLforum.com

For something i'm working on, I need a pic of a .22lr bullet and a .223/5.56 bullet together. Preferably of similar weights, but as long as I know what each's weight is, that works...

I have several different bullets, one from each of my guns, laying side by side, that I did for a research assignment last semester. Happy to send it to you. No idea of how to post a pic on here.

LaserTex@gmail.com

Doug

I don't know if this helps or if it's even what you want but...

I found plenty of pictures like that, I need the actual BULLETS, not the whole cartridge :/

I have a 55 gr .223 bullet on the reloading table, but I haven't been able to pull a .22 bullet without buggering it to bits yet. Any suggestions on how to do that? I can shoot you a photo then, and it would be a 40gr .22 to go with the 55gr .223 bullet.

You're doing better than I am, I set the primer off when I tried :(

nitrogen wrote:I found plenty of pictures like that, I need the actual BULLETS, not the whole cartridge :/

O ...

nitrogen wrote:You're doing better than I am, I set the primer off when I tried :(

Whoops... I've been using 2 pairs of pliers - one for the case, and one for the bullet. I'll try to wrap the bullet with something today and see if that will work a little better.

If there was just a way to Dremel the case open without it going BOOM, this would be a lot easier!

How about these:

.22


.223


Edit to add: .223 55 grain, .22 40 grain

1) 22WRM Winchester 40gr JHP (gray box)
2) 22LR CCI Velocitor 40gr HP
3) 22LR CCI Mini-Mag 40gr Solid
4) 22LR Remington Golden Bullet 38gr HP
5) 22LR Remington Subsonic 38gr HP
6) 22WRM Reminton Premier V-Max 33gr V-Max

Let's see if this is what you need. This is a 55gr .223 FMJ bullet posing with a 36gr .22 HP bullet.