Page 1 of 1
Re: Universal decapping die
Posted: Sat Apr 30, 2011 6:35 am
by Griz44
I tumble clean with primer in, then resize, then tumble again to get the lube off. Then trim and clean pockets.
What is your normal sequence of loading that would cause 2 resizings?
Re: Universal decapping die
Posted: Sat Apr 30, 2011 2:12 pm
by MoJo
A universal decapping die is a handy addition to any reloader's setup. I have a Lee and it's been doing yeoman's duty for me.
Re: Universal decapping die
Posted: Sat Apr 30, 2011 11:25 pm
by Griz44
By the way the trimmer is on it's own toolhead.
I see, my trimmer is off the press, so it is a separate step for me.
Re: Universal decapping die
Posted: Mon May 16, 2011 12:42 am
by medalguy
I use a Universal decapping die, then size & trim with the trimmer mounted in a Rockchucker, then prime in an RCBS Autoprime mounted on the table, and finally charge, seat, and crimp on the Dillon. That's a few extra steps but I can assure myself of a properly seated primer that way and it gives me one more look at the brass before I seat the bullet.