Page 1 of 1

WTS: Ruger Bisley Target in .357 Magnum

Posted: Wed Aug 22, 2012 9:05 am
by TxDrifter
I recently acquired this in a trade and it is a beautiful piece, but I just know it would end up a safe queen as I likely would not take it to the range that often. I was told it has never been fired and it looks it. It is a newer model Ruger Blackhawk Target model with the Bisley rollmark on the cylinder. This is a single action firearm, so it is very much "cowboy" style and just a beautiful sidearm. I have the original case with lock and paperwork as well.

I have seen the new rate for these is near $600. I am asking $500, but will entertain any reasonable offers. That means don't ask me what the lowest I will go instead, make an offer.

Image
2012-08-22_08-23-52_483 by jeolds, on Flickr

Image
2012-08-22_08-23-37_17 by jeolds, on Flickr

Image
2012-08-22_08-24-38_623 by jeolds, on Flickr

I am not seeing these on Ruger's website any longer in the .357 Mag version as they were a limited edition, but this is the details on those they have.
http://www.ruger.com/products/newModelB ... odels.html

Re: WTS: Ruger Bisley Target in .357 Magnum

Posted: Wed Aug 22, 2012 4:10 pm
by TxDrifter
Yes it is a 7.5" barrel. The rear sight is adjustable with a flat head screw head similar to how you adjust an M16 with a bullet tip. I haven't shot it, but it does feel good in the hand. I was pretty impressed with it.

Re: WTS: Ruger Bisley Target in .357 Magnum

Posted: Wed Aug 29, 2012 12:08 pm
by TxDrifter
Sorry folks. There wasn't a lot of interest on here, so I listed it on Gunbroker.