So, we finished my wife's tonight. There are a couple of odds and ends that need to be taken care of:
1. forgot to mount the sling swivel to the gas block, so I'll have to remove the handguards so I can get clearance to drive the pin in.
2. I had a spare ER Shaw M4 1:9 barrel and A2 flash hider, but I can't find the crush washer that goes under the flash hider, so right now it's just screwed on by hand. I've got to order a washer from somewhere.
3. Couldn't find a gas tube pin in my box o' parts to anchor the gas tube into the gas block, but I had another pin that was the right fit, but just a little too long, so I used it. But I've got to order the correct pin.
Other than that, here are the basics:
- SOG Armory lower receiver
- DPMS lower receiver parts kit
- DPMS commercial tube
- Yankee Hill Machine assembled upper
- Daniel Defense bolt/carrier assembly
- ER Shaw M4 1:9 barrel
- A.R.M.S. #40L-P flip up rear BUIS
- Vortex Strikefire red dot sight with 2X magnifier
- Burris XTR High Ring
- Magpul MOE 6 position collapsible buttstock and MOE carbine length handguard




