WTS: S&W 625-3 Model of 1989 4"

[GrandmasterB]

Smith & Wesson 625-3 Model of 1989 revolver chambered in .45 ACP with 4 inch barrel, uses moonclips and is great for IDPA or USPSA. Trigger job by Teddy Jacobson of Actions by T. SDM fiber optic front sight and Weigand combat rear sight. Cylinder holes chamferred for faster reloads. This is a pre-lock gun with the firing pin on the hammer. Trigger and springs set to run with Federal primers. You may want to replace springs if you want to shoot factory ammo through this baby! This is a used gun. It has a few nicks and scuffs on it. It is made to be shot and loved, not babied and kept in the safe! I used this gun to finish 2nd in Sharpshooter in the 2003 TX State IDPA match.





Grips in the pics are Hogues with the finger grooves ground off. I will swap those out for a non-modified set of Hogue rubber grips upon sale.

$725 + $25 shipping, or FTF in DFW.

Not looking for trades at this time.

[A-R]

[LongHairedRedneck]

+1 on the drool

[Seabear]

If I hadn't just bought a 625 Jm, I'd be all over it. Cool revolver for sure.

[The Annoyed Man]

Man that sure is pretty.

[bkj]

All the good stuff is so far away

[GrandmasterB]

SOLD